Re: [Harp-L] attaching reeds using screws

I have found most of what I am after on the site, but I would still like to get any related advice of info. Thanks.

Doug H
  ----- Original Message ----- 
  From: Doug 
  To: Harp-L@xxxxxxxxxx 
  Sent: Saturday, May 29, 2010 9:22 PM
  Subject: [Harp-L] attaching reeds using screws

  I am having some reed plates custom made and intend to attach the new reeds with screws rather than rivets.  I have seen examples of small self-tapping screws being used but I want to tap the holes myself and use small machine screws, similar in size to the ones used to hold marine (and other harps) bands together.

  I need to find out:

  What size screws are those that are used on reed plates?  

  What is the next size smaller or is that too small?

  What is the diameter of the typical (Hohner) rivet hole?  How do you measure that accurately?  Is there a special tool?

  Where would I get a tap for threading the holes?

  Etc, etc.

  If any of you tech oriented folks has some answers, or some leads, please let me know.  Thanks in advance.

  Doug H


  No virus found in this incoming message.
  Checked by AVG - 
  Version: 9.0.819 / Virus Database: 271.1.1/2903 - Release Date: 05/29/10 00:25:00

This archive was generated by a fusion of Pipermail 0.09 (Mailman edition) and MHonArc 2.6.8.