RE: [Harp-L] Wireless Volume Question/Issue
Funny you mention the battery. Heh. It could be that - I'll have to get
rigged back up this weekend and check.
I have Lithium Ion rechargeables and I usually charge the day of the jam
but didn't do that this time. Heck I only used it once since the last
charge :^) but I guess these transmitters can suck them up early. I'm a
little skeptical since this was used for 3 sets by 3 different harp
players at the jam last night and it didn't seem to get worse as I would
expect if the battery was low on charge. But perhaps. And I know I've
heard that rechargeables might not be the best to use, just to get
regular alkalines so I'll put a test plan into effect to see what the
deal is there.
From: harp-l-bounces@xxxxxxxxxx [mailto:harp-l-bounces@xxxxxxxxxx] On
Behalf Of Tim Moyer
Sent: Friday, April 06, 2007 4:06 PM
Subject: Re: [Harp-L] Wireless Volume Question/Issue
Bill Hines wrote:
> I have an AKG WMS40/SO40 and use that with an Audix Fireball V.
> Question if anyone knows - when i go through the wireless to
> either my sonny jr or the deluxe reverb, i have to crank the amp
> volume way up to almost max. when i go in with the same mic
> directly to the amp, volume of 2 or 3 is about the same loudness
> as max through the wireless. what gives? I don't think this was
> the case before, something must have changed. I checked the volume
> on the wirelss receiver (maxed), my mic (maxed), the gain on the
> wireless transmitter (max), etc. only thing i can think is maybe
> the receiver is picking this up as a lo-z signal now for some
> reason? again I don't think this was going on last time I used
> the wireless.
> The cord from the wireless receiver to the amp is a Soundflex by
> VTG 20GA/1C instrument cable, 1/4" on both ends, into the 1/4"
> unbalanced jack on the wireless. Could it be a lo-z cable or some
> thing? I haven't tried other cables, so maybe that's it but I'm
> doubtful. There's also a crack I noticed near one of the XLR pin
> inputs on the SO40 transmitter, maybe this is causing a weak
I don't know specifically what's wrong, Bill, but I run all my
adjustments in just about the opposite setting from you: my receiver
output volume is MIN, my trasmitter gain is MIN, and the output from
my wireless is about the same as it is cabling directly from the mic
to the amplifier input. You should set those volumes closer to
their minimums or you're going to get all kinds of unwanted
distortion and clipping.
Of course, check the cable, replace it with another and see if the
problem persists. I don't know of any way to test the transmitter,
but I'd be suspicious of that crack. I guess it would be silly to
ask if you've checked the battery...
Harp-L is sponsored by SPAH, http://www.spah.org Harp-L@xxxxxxxxxx
This archive was generated by a fusion of
Pipermail 0.09 (Mailman edition) and