[Harp-L] Re: Harp-L Digest, Vol 39, Issue 17



After countless times of trying to hear myself on stage I recently started using the same set up as James.
I place the amp on an amp stand in front of me using it like a monitor. My current gigging amp is a 15 watter. I added a line out so I can plug it into a direct box then into the pa. I use this set up for all gig situations whether in a bar or on a large concert stage. It may take a few sets to get the level right. I turn the volume loud enough so I can hear myself and let the guy running the board set the level for out front. Have the guy running sound put you in the monitor mix if you need more stage volume.


mike
On Nov 13, 2006, at 3:31 PM, harp-l-request@xxxxxxxxxx wrote:

Message: 7
Date: Mon, 13 Nov 2006 12:56:49 -0500
From: "James Sterett" <jsterett@xxxxxxxxx>
Subject: Re: [Harp-L] the oldest discussion on the planet
To: "Sloppy Joe" <special20@xxxxxxxxx>, <harp-l@xxxxxxxxxx>
Message-ID: <45586ADD.5AA5.003F.0@xxxxxxxxx>
Content-Type: text/plain; charset=US-ASCII

SJ, a simple setup that works for me when playing electric (for which I use an amp that's probably no more than 6W) is one of those tilt amp stands, I point the amp right up at me and mic the amp through the PA. this basically make my amp my stage monitor... leaving the soundman to worry about the house. The soundman should have plenty to work with as far as volume from your miced amp, and if they don't get you in the mix after that, it's a human issue and no equipment's going to solve that.






This archive was generated by a fusion of Pipermail 0.09 (Mailman edition) and MHonArc 2.6.8.