Re: [Harp-L] Help with Chromatic repair



Brad
 EBay had...Herring plastic comb replacement for 270s new reeds, windsavers included.
All you need is the side covers, screws and slide assembly from the Horner and you have a new chromatic.
Hope this helps


Mike Wilbur



On Jan 16, 2014, at 4:21 PM, harp <harp@xxxxxxxxx> wrote:

> Dear Harp-L,
> 
> I have always played the diatonic harp, but have been curious about the chromatic.  I recently purchased a couple of older Hohner Chromonicas â one is a 10-hole, and the other is a âsuperâ 12 hole.  Both have wood combs, and both are in need of maintenance.  I regularly work on my diatonics, but I have never had a chromatic before, so I am jumping right into the deep end of the swimming pool and am going to do some work on these to see if I can make them fully functional.  But I need some help/parts.
> 
> I have already cleaned them up some, and I have opened up the gap on some reeds that were choking and have âironed outâ a reed that had been bent.  100% better already, but I still have a long way to go.  Here are the issues where I could use some advice:
> 
> -  Both harps have broken combs.  The Super has a vertical crack on the 10-hole that is between 1/16â and 1/8â wide.  This means that both the upper and lower reeds of hole 10 play regardless of where the slide is positioned.  The 10-hole Chromonica also has a vertical crack in the comb, but it is not at all as bad, and it does not seem to leak enough air between the upper and lower chambers to affect how it plays.  Does anyone have any recommendations on repairing the comb?  I can think of several ways to go about it, but I thought I would ask the group first.
> -  Of course, the windsavers are shot.  Should I just buy the windsavers from Hohner (currently out of stock â anyone have some they would like to sell?)
> -  Any suggestions on how to punch rivet holes in the windsavers short of buying the $350 Hohner tool kit?
> -  Does anyone have some of the slide buffers (the little pieces of plastic tubing that cover the mouthpiece screws)?
> 
> Thank you very much,
> Brad




This archive was generated by a fusion of Pipermail 0.09 (Mailman edition) and MHonArc 2.6.8.