Re: [Harp-L] Help with Chromatic repair

Rivet holes in wind savers: Have you replaced rivets with screws or
screws/nuts?  You should not need to punch holes for any other reason.

Broken wood combs:  Everybody has a method of repairing wood chromatic
combs.  Or you can replace the comb with plastic.  Later this year, I
will to begin production of the Miklas Lifetime Comb to replace wood and
aluminum chromatic combs in 10, 12, 14, and 16 hole models.  Individually
milled from solid ABS, Delrin, or Acrylic, with threaded metal inserts so
that reed plates and cover plates can be removed individually. More
information will be made available as it develops on my website:


On Thursday, January 16, 2014, harp <harp@xxxxxxxxx> wrote:

> Dear Harp-L,
> I have always played the diatonic harp, but have been curious about the
> chromatic.  I recently purchased a couple of older Hohner Chromonicas – one
> is a 10-hole, and the other is a “super” 12 hole.  Both have wood combs,
> and both are in need of maintenance.  I regularly work on my diatonics, but
> I have never had a chromatic before, so I am jumping right into the deep
> end of the swimming pool and am going to do some work on these to see if I
> can make them fully functional.  But I need some help/parts.
> I have already cleaned them up some, and I have opened up the gap on some
> reeds that were choking and have “ironed out” a reed that had been bent.
>  100% better already, but I still have a long way to go.  Here are the
> issues where I could use some advice:
> -  Both harps have broken combs.  The Super has a vertical crack on the
> 10-hole that is between 1/16” and 1/8” wide.  This means that both the
> upper and lower reeds of hole 10 play regardless of where the slide is
> positioned.  The 10-hole Chromonica also has a vertical crack in the comb,
> but it is not at all as bad, and it does not seem to leak enough air
> between the upper and lower chambers to affect how it plays.  Does anyone
> have any recommendations on repairing the comb?  I can think of several
> ways to go about it, but I thought I would ask the group first.
> -  Of course, the windsavers are shot.  Should I just buy the windsavers
> from Hohner (currently out of stock – anyone have some they would like to
> sell?)
> -  Any suggestions on how to punch rivet holes in the windsavers short of
> buying the $350 Hohner tool kit?
> -  Does anyone have some of the slide buffers (the little pieces of
> plastic tubing that cover the mouthpiece screws)?
> Thank you very much,
> Brad


   - *GEORGE MIKLAS,* Harmonica Performing Artist and


   - *HARMONICA REPAIR* Done Right by George<>
   - *HOHNER <>*
   Breathe* <>
   - *SPAH *- *S*ociety for the *P*reservation and *A*dvancement of the *H*
   armonica, <>
      - *a non-profit, membership organization dedicated to serving the
      harmonica community. <>*

This archive was generated by a fusion of Pipermail 0.09 (Mailman edition) and MHonArc 2.6.8.