[Harp-L] fun with reed replacements
- To: harp-L list <harp-l@xxxxxxxxxx>
- Subject: [Harp-L] fun with reed replacements
- From: Robert Hale <robert@xxxxxxxxxxxxxx>
- Date: Sat, 18 Jun 2011 19:10:18 -0700
- Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=gamma; h=domainkey-signature:mime-version:sender:date:x-google-sender-auth :message-id:subject:from:to:content-type; bh=aiwH7D58uX1QOhwez+zh/UFzXhILxQj1DHwi+Pjoq8Q=; b=fI213r2ppwMHIw/HFUliWhvx1AmFrLt8U5U55+0AObvtTxzAMPVxMc4d21OyZq5Ld/ 3+j3x7mXVMVtqghaHm8CsuDIBjrI1trcZOdlYYiMfWXk6llKgpDnxK870TmTKgV1QZQX XhDOCTlxh0IDBBg47xidkR2UomRjF8ZFXkbuY=
- Domainkey-signature: a=rsa-sha1; c=nofws; d=gmail.com; s=gamma; h=mime-version:sender:date:x-google-sender-auth:message-id:subject :from:to:content-type; b=RaOrfwmncqiyfoVRJipnev9H8tqZPdHpb/rSLU6JCZ2U23U8Cr3W8PG2Z6ExbTWXLI aba3BL7t1l4ZVk1i0BK3zmWQplTUJ1RVv2wTuvhvXH6GizQbO5HOABj0OU0PSXIuksZy sBMtohJOvE8Vx5b18K3nVQZ0DyhV2OoByzxqw=
- Sender: ynfdwas@xxxxxxxxx
FIRST EFFORTS
Punched rivets out of reeds on LO plates using Custom Craft plexiglas tool.
(Rivets seem to come out of LO easier than from SP20.) Used 0090 bolt/nut
set from MicroMark. Nut driver from Model Motorcars LTD made the job MUCH
easier. Thanks for the advice on that.
RESULTS
For practice, decided to exchange the blow 1 reeds from two old LO plates
key of D, but found reeds not a perfect match. With one, the donor reed sat
too long for the slot. The other sat a bit to the side of the slot. In both
cases, enough to hang the reed.
Are there any known LO dimension changes over time? Reeds appear identical,
so hole-centering is probably the error.
Your experience?
Stay well
Play well
Robert Hale is the DUKE of WAIL
Distance Learning via Webcam
http://www.dukeofwail.com
Gilbert AZ (Phoenix)
This archive was generated by a fusion of
Pipermail 0.09 (Mailman edition) and
MHonArc 2.6.8.