RE: [Harp-L] tacks for Hohner 270

["Patrick Powers" <patpowers@xxxxxxxxxxx>]

Hi Sam,

You can probably just take one with you to your local hardware store and
ask them to match it up for you.  Make sure you use brass or stainless
steel, as plain steel will rust. 

OR, you can drill and tap per George's recommendations , but I wouldn't
recommend that for the not-so-mechanically inclined.  I don't know if
you have any experience with that sort of thing or not.

Hey, and if you're REAL handy around the house (like Red Green) you can
probably just use some Elmer's glue and duct tape.  ....just kidding
man, don't do that.
 
I hope this information helps.

  0+
  \_/

-----Original Message-----
From: harp-l-bounces@xxxxxxxxxx [mailto:harp-l-bounces@xxxxxxxxxx] On
Behalf Of sam Blancato
Sent: Thursday, September 09, 2010 5:05 PM
To: Harp-L
Subject: [Harp-L] tacks for Hohner 270


Does anyone know where I can obtain the little nails that hold the 270
reed
plates to the comb?  If there is another supplier other than Hohner then
what size would they be?
 
Sam Blancato, Pittsburgh
No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 9.0.851 / Virus Database: 271.1.1/3124 - Release Date: 09/09/10
02:34:00