Re: [Harp-L] Hohner M.S. Question

[Fernando Bresslau <bresslau@xxxxxxxxx>]

Hi, all.

The tips given so far are good, I have used them in Brazil also. 

The screws are Pozidrive type, which is similar to Phillips, with an
extra less prominent cross on the bit. Its symbol is a kind of 8 point
star. At the size of the MS screws, this extra cross is almost non
existent, so one can do with phillips screw drivers. But pay attention
that the pozidrive is less sharp than phillips, and that you use a
screwdriver with a good fit. If the driver is not adequate, you will
strip the head of the screw very quickly.
Another tip: try to use the screw instead of the nut when
assembling/disass. The nut has a hole through it, which makes it a tad
weaker.

All the best,
Fernando