Re: unresponsive reed

["Oliver Schoenborn" <oliver.schoenborn@xxxxxxxxxxx>]

> Check the gap on both the draw and blow reeds of the 3 hole, should be
about
> the thickness of the reed. In theory the gap goes up a bit at each reed as
> you go down in frequency, so check for consistency.

Just noticed this: in my post just two minutes ago, I said the #2 blow is
the only one that has a gap different than its neighbors (and #3 is the one
with the problem), actually #2 gap seems much smaller than the thickness of
the reed. And it responds fine. Another confusing point.

Oliver