[Harp-L] Re: harmonica stands

["Ken.H" <airmojo@xxxxxxxxxx>]

I made a harmonica case and stand similar to the 
Masterclass stage case, using an inexpensive aluminum
tool case and tripod microphone stand.

I bought the aluminum tool case at a local Tractor Supply 
for about $17.00 plus tax, and I've seen the same case at 
Home Depot for around $20.  Its a decent case that comes 
with foam that has been pre-cut in about 1/2 inch sections 
so that you can customize your needs (I still haven't finished this part yet).  

There's a foldout 'tool' holder in the top of the case that has various pockets,
but I removed them (kind of pain, as they are stitched in, and replaced 
them with stretch elastic bands, riveted to the board, so it will hold various
harmonicas better.  You can also place cords, paper documents etc behind 
this foldout board.

I did a quick websearch and this is pretty much the same case:

http://www.outpost.com/product/2649032

On the bottom of the case, I added a galvanized steel floor flange 
and short threaded pipe (3/4 inch diameter I think) drilled and tapped 
for a threaded wingnut to hold the case on the microhone stand.

I preferred the collapsible tripod stand over the heavy weighted stand 
because the tripod stand is lighter and can be attached to the case in 
some manner (haven't got that far yet).

Its been a fun project, and not a whole lot of money into it, just some time
(which is why I haven't quite finished it yet!)

Ken Hildebrand




_______________________________________________
Join Excite! - http://www.excite.com
The most personalized portal on the Web!