RE: [Harp-L] Embossing/burnishing reed slots - was Gapping for Overblows

["Chris Michalek" <Chris@xxxxxxxxxxxxxxxxxx>]

That would work for the draw reeds only

>
>
>
>---- Original Message ----
>From: Captron100@xxxxxxx
>To: harp-l@xxxxxxxxxx
>Subject: RE: [Harp-L] Embossing/burnishing reed slots - was Gapping
>for Overblows
>Date: Fri, 6 Aug 2004 15:59:02 EDT
>
>>In a message dated 8/5/04 11:33:17 PM Eastern Daylight Time, tim
>moyer wrote:
>>
>>> >Embossing (or here "burnishing") is done from the reed side of
>the 
>>> >plate, and yes, it will require the harp to be completely 
>>> >disassembled. 
>>
>>Thanks, tim.  Why must the harp be totally disassembled?  Why
>cantcha just do 
>>your embossing on top of the reed, with the harp intact?
>>ron
>>_______________________________________________
>>Harp-L is sponsored by SPAH, http://www.spah.org
>>Harp-L@xxxxxxxxxx
>>http://harp-l.org/mailman/listinfo/harp-l
>>

"I assure you sire that I did not play one more or one note less than
absolutely necessary" - Mozart