Returned mail: User unknown (fwd)
---------- Forwarded message ----------
Date: Fri, 3 Jun 1994 14:20:46 -0700
From: Mail Delivery Subsystem <MAILER-DAEMON@xxxxxxxxxxxxxxxxxxxxxxx>
To: barrys@xxxxxxxxxxxxxxxxxxxxxxx
Subject: Returned mail: User unknown
The original message was received at Fri, 3 Jun 1994 14:20:36 -0700
from barrys@localhost
----- The following addresses had delivery problems -----
"harp-l@xxxxxxxxxxxxxx%RAPNET.dnet"@rapnet.sanders.lockheed.com (unrecoverable error)
----- Transcript of session follows -----
... while talking to osprey.telcom.arizona.edu.:
>>> RCPT To:<harp-l@xxxxxxxxxxxxxx%RAPNET.dnet@rapnet.sanders.lockheed.com>
<<< 553 bad address syntax: harp-l@xxxxxxxxxxxxxx%RAPNET.dnet@rapnet.sanders.lockheed.com
550 "harp-l@xxxxxxxxxxxxxx%RAPNET.dnet"@rapnet.sanders.lockheed.com... User unknown
----- Original message follows -----
Return-Path: <barrys>
Received: from localhost by convx1.ccit.arizona.edu; Fri, 3 Jun 1994 14:20:36 -0700
Date: Fri, 3 Jun 1994 14:20:35 -0700 (MST)
From: Barry Schaede <barrys@xxxxxxxxxxxxxxxxxxxxxxx>
Subject: Re: electric harp question
To: Harp-L@xxxxxxxxxxxxxx
cc: "harp-l@xxxxxxxxxxxxxx%RAPNET.dnet"@rapnet.sanders.lockheed.com
In-Reply-To: <9406031301.AA13556@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
Message-ID: <Pine.3.89.9406031404.A15438-0100000@xxxxxxxxxxxxxxxxxxxxxxx>
MIME-Version: 1.0
Content-Type: TEXT/PLAIN; charset=US-ASCII
Depends on what you want to do. Until recently I've always preferred
miking my amps. Have you seen Gerald Weber's new book? A desktop
reference of hip vintage guitar amps. On page 218 he describes a
resistor network that attaches to the speaker terminals and has a 1/4"
phone jack on the other end. I've been using this lately on my 59
Bassman with good results. The tone seems purer, more like the amp
sounds by itself. The other benefit of course is no feedback problems
from the pa mic. If you play through tube amplifiers I cannot reccommend
this book enough. It's available from Kendrick amplifiers (512)990-5486
Pflugerville TX. fjm
On Fri, 3 Jun 1994 jesmith%nhqvax.dnet@xxxxxxxxxxxxxxxxxxxxxxxxxxx wrote:
> Is it better to "line out" from an amp (using it as a pre-amp) to a
> PA or to mike to amp through the PA, assuming one wants the benefits of
> the amp sound and to go through the PA.
>
This archive was generated by a fusion of
Pipermail 0.09 (Mailman edition) and
MHonArc 2.6.8.